|
Toe Cap Impact Tester
The toe portion of shoes
used for industrial applications or used in mines shall be sufficiently
rigid so as not to get pressed down beyond a specified limit when a
heavy block falls down on it, thus preventing crushing of or injury to
the toe of the user. The toes of miner's safety boots or industrial
shoes are generally reinforced with a steel toe-cap to provide rigidity
to them. Whether these toe-caps are sufficient robust so as to fulfill
their desired function is ascertained by subjecting the toe-cap
assembled in a cut-out shoe to an impact by a falling weight in a
suitable equipment. The toecap shall not press down beyond a specified
limit during the impact.
The GLOBE Toe Cap Impact
Tester consists of a rigid fabricated mild steel frame with two hard
chrome plated carbon steel rods to act as guides for the falling
weight, an arrangement to allow the weight to fall and strike the
toe-cap under test, a hardened clamping block made from die steel on
which the toe-cap under test can be held with the help of crescent
shaped clamp, and a heavy mild steel anvil block on which the clamping
block is rigidly mounted.
The height of fall can be
adjusted to compensate for varying heights of toe-caps by adjusting the
position of the locking pin fixed on the dropping weight. The dropping
weight is lifted with the help of a chain and hand wheel and is held in
lifted position by the locking pin resting on a release lever. The
chain is removed from the weight after lifting and the weight is
dropped by pulling the release lever.
The tester is finished in shore blue matalic painting and bright chrome plating to give it a corrosion resistant finish.
The 600 kg mass base over which the tester is to be bolted is not supplied with the tester and has to be provided by the user.
A special bench type
thickness gauge of 25 mm range having a hemispherical foot of 3.0 mm
radius applying a force of 250 mN (25 g) and a hemispherical anvil of
15 mm radius for measuring the thickness of modeling clay after impact
is available as an optional accessory.
Split type moulds for
preparing cylinders of modeling clay for placing inside the toecaps
and a torque screw driver needed to tighten the clamping bolt to a
torque of 3.0 N.m are also available against specific requirements.
Technical Specifications
Height of fall
|
1020 +- 10 mm
|
Mass of falling block
|
10.0 +- 0.1 kg and 20.0 +- 0.2 kg
|
Impact energy
|
100 +- 2 Joule and 200 +- 4 Joule
|
Striker
|
Wedge shaped having an included angle of 90o, length of at
least 60 mm, edge rounded to 3 mm radus, hardness 50 to
60 HRC
|
Clamping block
|
150 x 150 x 19 mm, hardness at least 60 HRC
|
Base block
|
400 x 400 x 40 mm approximately
|
Related Specification
|
EN 34 - 1993
|
Requirements and Test Methods for Safety, Protective and
Occupational Footwear for Professional Use
|
|
